Limestone Aggregates Processing

Solution

LIMESTONE AGGREGATES PROCESSING

limestone

DESIGN OUTPUT
According to customer needs

MATERIAL
It is suitable for primary, secondary and tertiary crushing of middle hard and soft rock such as limestone, dolomite, marl, sandstone and clinker, etc.

APPLICATION
It is applied for primary, secondary and tertiary crushing of various middle hard materials in the industries of chemical, cement, building and refractory.

EQUIPMENTS
Jaw crusher, impact crusher, sand maker, vibrating feeder, vibrating screen, belt conveyor.

INTRODUCTION OF LIMESTONE

Limestone is the trade name of limestone as mining raw material, it has a very wide distribution with abundant reserves. The main component of limestone is CaCO3. Its Moh's hardness is 3. It is an important road construction material, and also it is an important material for calcinating lime and cement, it is an indispensable high calcium lime to metallurgical industry, after ultrafine grinding, high quality limestone can be widely applied in the production of paper making, rubber, paint, coating, medical, cosmetic, feed, sealing, adhesion, polishing. The compressive strength of limestone is typically about 150 MPa, it belongs to soft rock, and therefore impact crusher is adopted for the production process of limestone production line. The proven Sanme impact crusher is a new type of impact crusher with high efficiency, and is suitable for crushing limestone and sandstone, 95% of crushed material <45mm.

BASIC PROCESS OF LIMESTONE CRUSHING PRODUCTION PLANT

The limestone crushing production line is divided into three stages: coarse crushing, medium fine crushing and screening.

The first stage: coarse crushing
The limestone stone blasted from the mountain is fed uniformly by the vibrating feeder through the silo and transported to the jaw crusher for coarse crushing.

The second stage: medium and fine crushing
The coarsely crushed materials are screened by vibrating screen and then conveyed by belt conveyor to cone crusher for medium and fine crushing.

The third stage: screening
The medium and finely crushed stones are conveyed to the vibrating screen through a belt conveyor to separate stones of different specifications. The stones that meet the requirements of the customer's particle size are conveyed to the finished product pile through the belt conveyor. The impact crusher crushes again, forming a closed circuit cycle.

limestone1

BASIC PROCESS OF LIMESTONE SAND MAKING PLANT

The Limestone sand making process is divided into four stages: coarse crushing, medium fine crushing, sand making and screening.

The first stage: coarse crushing
The pebbles blasted from the mountain is fed uniformly by the vibrating feeder through the silo and transported to the jaw crusher for coarse crushing.

The second stage: medium broken
The coarsely crushed materials are screened by vibrating screen and then conveyed by belt conveyor to cone crusher for medium crushing. The crushed stones are conveyed to the vibrating screen through a belt conveyor to sieve out different specifications of stones. The stones that meet the requirements of the customer's particle size are conveyed to the finished product pile through the belt conveyor. The cone crusher crushes again, forming a closed circuit cycle.

The third stage: sand making
The crushed material is larger than the size of the two-layer screen, and the stone is conveyed to the sand maker machine through the belt conveyor for fine crushing and shaping.

The fourth stage: screening
The finely crushed and reshaped materials are screened by circular vibrating screen for coarse sand, medium sand and fine sand.

limestone2

Note: For the sand powder with strict requirements, a sand washing machine can be added behind the fine sand. The waste water discharged from the sand washing machine can be recovered by the fine sand recycling device. On the one hand, it can reduce environmental pollution, and on the other hand, it can increase sand production.

Technical description

1. This process is designed according to the parameters provided by the customer. This flow chart is for reference only.
2. The actual construction should be adjusted according to the terrain.
3. The mud content of the material cannot exceed 10%, and the mud content will have an important impact on the output, equipment and process.
4. SANME can provide technological process plans and technical support according to the actual requirements of customers, and can also design non-standard supporting components according to the actual installation conditions of customers.

PRODCUT KNOWLEDGE